Decal Application Instructions

COLDER TEMPERATURES WILL CAUSE THE VINYL TO NOT STICK PROPERLY!

Die cut vinyl decals look amazing but can confuse people who are used to just peeling a sticker and slapping it on. Here are some easy steps to get it right the first time.

Step 1: Clean the area thoroughly - we recommend using rubbing alcohol.

Step 2: Carefully peel the two pieces apart, removing the backing and leaving the decal on the application sheet. If your decal is sticking to the backing, close the sticker and start again, changing the angle of your peel maneuver. The half that is pulled away at the sharper angle releases the decal. 

Step 3: Once you have your decal completely on the application sheet, line it up where you want it, using the light adhesive on the application sheet to hold the decal in place. While one hand holds the decal away from the surface, use your free hand to apply the decal by smoothing it onto the surface as you go up. This reduces the chances of bubbles. 

Step 4: Once you have the decal on, use your finger and firmly press along every surface of the decal through the application sheet.

Step 5: Peel the application surface off using a very aggressive angle to avoid peeling the sticker back off. If you see the sticker coming off, stop, press it back on, and try again, making that removal angle as high as you can

 
Pro Tip

These are small decals and you should’t get bubbles. You can squeeze bubbles out that are close enough to the side of the decal with your finger. If you managed to get one bubble in the middle of the decal, wait for a hot sunny day, use a pin and lightly put a hole in it. When it is hot the vinyl is soft and it will adhere back down and stretch back to place like it was never there.